How to Get Neodymium Magnets from Speakers

If you want to get neodymium magnets from speakers, you’ll need to disassemble the speaker. This can be done by unscrewing the screws that hold the speaker together and then separating the parts. Once you have the neodymium magnet, you can use it for a variety of purposes.

For example, you could use it to create a DIY electromagnet or make your own magnetic Levitation device.

  • Neodymium magnets are found in speakers
  • To get them, you will need to disassemble the speaker
  • Use a screwdriver to remove the screws that hold the speaker together
  • Carefully take the speaker apart, being careful not to damage any of the components inside
  • Locate the neodymium magnets inside the speaker and remove them
How to Get Neodymium Magnets from Speakers


How Do You Separate Magnets from Speakers?

If you have ever taken apart a speaker, you may have noticed that there are magnets inside. These magnets are what create the sound that comes out of the speaker. In order to separate the magnets from the speakers, you will need to use a tool called a demagnetizer.

This tool will safely remove the magnetism from the magnets so that they can be removed without damaging the speaker.

Do Speakers Have Neodymium Magnets?

Speakers rely on electromagnetism to produce sound. An electric current is passed through a wire coil, which creates a magnetic field. This magnetic field interacts with a permanent magnet in the speaker, causing the speaker cone to vibrate and produce sound.

The permanent magnet in the speaker is typically made from ferrite or neodymium. Ferrite magnets are made from iron oxide and have excellent corrosion resistance. They are often used in lower-end speakers where cost is a factor.

Neodymium magnets are made from an alloy of neodymium, iron, and boron. They are much stronger than ferrite magnets and allow for smaller, more efficient speakers. However, they are also more expensive.

How Do You Turn a Speaker into a Magnet?

In order to turn a speaker into a magnet, you must first remove the current flowing through the voice coil. This can be done by disconnecting the speaker wire from the amplifier or by removing the fuse from the amplifier. Once the current is removed, you can then use a permanent magnet to create a magnetic field around the voice coil.

This will cause the speaker to become a magnet.

Are Speaker Magnets Strong?

Yes, speaker magnets are strong. They have to be in order to create the electromagnetic field necessary to produce sound. The strength of a speaker magnet is measured in gauss units.

The average refrigerator magnet is about 100 gauss. Speaker magnets can range from 200-1200 gauss.

9 way to find Free Powerful Neodymium Magnets

How to Remove Magnet from Subwoofer

If you have a subwoofer that uses magnets, you may be wondering how to remove them. Magnets are powerful and can be dangerous if not handled properly. Here are some tips on how to remove magnets from your subwoofer safely:

1. Use gloves or other protective gear when handling the magnet. 2. Use a screwdriver or other tool to loosen the screws that hold the magnet in place. 3. Carefully pull the magnet out of the subwoofer.

Avoid dropping it as it could damage the speaker coil underneath. 4. Dispose of the magnet properly. Do not put it in the trash where it could be accidentally picked up by someone else and cause injury.


If you want to get neodymium magnets from speakers, you’ll need to disassemble the speaker. Once you have the speaker dismantled, you can remove the neodymium magnet from the center of the speaker cone. With a little bit of effort, you can then reuse the magnet for other purposes.